USD
EUR
GBP
AUD
Manual:
GUI settings:
Throttle range calibration video:
Rhino Crawler 40A
This ESC preloaded AM32 custom firmware. It's optimized for crawler and makes your car run super smooth and quiet, but it is also suitable for a variety of 1/10 scale or smaller cars. A built-in adjustable four voltage BEC with a maximum current 3A. In addition, the e-Switch that comes with it avoids failures caused by harsh environments.
All wires are pre-soldered.
Feature
AM32 custom firmware
Sinewave startup allows the motor smoothly at ultra-low speeds Variable drive frequency
Low voltage, throttle loss and stalled rotor protection
High-performance 32-bit MCU
E-switch with long life and waterproof
Specs
Product Num.: A3110
Battery: 2~4S Lipo
Current: 40A cont.
BEC: max 3A, output 5.2~8.2V adjustable by DIP switch
Waterproof: ESC not supported / e-switch supported
FAN: not supported
Connectors: not include
Wires: battery 16AWGx100mm, output 16AWGx100mm, signal 200mm and e-switch 120mm
Dimensions: 39x26x11mm (without wires)
USB-Link
Suitable for a variety of ESCs, such as AM32/BL32, etc., connect ESC to computer for configuration or upgrade firmware.
It is portable and easy to use, just connect the ESC signal plug, connect the USB Type-C cable to the computer and install the VCP driver.
Specs
Product Num.: EUL-01
Wires: not include
Dimensions: 25x13x11mm
