Ultramicro FPV RX XR401-F2(FRSKY-D16) SBUS/FPORT/RSSI

XR401-F2 is totally new designed receiver, which has a multifunctional UART port（DMA operation） for double and two-way communication, it can outpu SBUS and FPORT signal at the same time, also support RSSI output and online firmware updating. It is 100% compatible with FRSKY-D16.

PRODUCT SPECIFICATIONS
Type: CROSSOVER RX XR401-F2(FRSKY-D16)  SBUS/FPORT/RSSI UltramicroFPVRX
Modulation: Compatible FRKSY-D16
Num of Channels: 16CH
Size: 10*13*2mm (without antenna)
RC Data output: SBUS(REV) & FPORT(NOR)
Supports digital RSSI output;
Variable RF Link;
High speed(9ms);
Weight: 0.45g
Voltage: 5.0V
Effective distance: >300m
Antenna Length:31mm

Connection Diagram(Choose SBUS or FPORT):

How to Bind:
1) Power ON receiver;
2) It will enter binding mode after 15s (slow flashing LED turns to fast blinking);
3) Bind to Radio(according to your radio manual)-Done(red LED constant bright)!

Antenna:
    Different with other antenna, the antenna on XR400 series receivers can be arbitrarily bended but no worry for damage or fallen off, so it would be no problem if it were installed in a limited confined place.

Variable RF Link technology:
Variable RF Link technology:  When the receiver is too close to radio(remote control), normally RF signal will be blocked and meanwhile lose control happens, Variable RF Link is born for solving the problem! As soon as Variable RF Link finds that the receiver is coming close to radio, it will adjust LNA gain and PA output power lower to avoid short distance control failure automatically;  When Variable RF Link detects that the receiver is going far away from radio, it will adjust LNA gain and PA output power higher to increase RX’s working range automatically.

DECLARATION：
1）The XR400 series RX are Not a copy or fake products of other companies；
2）MXO-RF and CROSSOVER-RX brand guaranteed its high quality and continuous technical service.