· Optimization for compatible Inductrix frame and pre-flash Betaflight firmware
· STM32F303CC with 32bit/72MHz/256K Flash/40K SRAM
· MPU6500 Sensors via SPI bus
· Receiver connector (RX2) with PPM/SBUS/DSM2/DSMX input
· 1~2S Li-Po supported
· Dimension 29x29mm / fixing holes spacing 25.4mm / Weight xg
Dimension: 29x29mm
Mounting holes: 25.4x25.4mm
MCU: STM32F303CC
IMU: MPU6500 (SPI) with Interrupt
Baro: No
VCP: Yes
OSD: No
Hardware ISP: 1 for IMU
Hardware uarts: 1 for receiver
Blackbox: No
PPM/UART share: RX2
Boltage sensor: On board voltage divider
Bottons: 1-dfu
Status leds: 1 Red
Alarm leds: 4 Red
Power: Li-Po 1~2s